DPF Back Milltek Cupra Formentor 2.0 TFSI 310 hp 2021-2025, non-resonated, Quad Jet-100 Carbon Tips

Milltek Sport DPF-back exhaust for Cupra Formentor

On the Cupra Formentor, the original exhaust is designed for quiet running and regulatory compliance. This Milltek Sport stainless steel DPF-back line gives the engine its voice back with a refined, full and deep sound, the one that built the reputation of this British brand.

Technical specifications

• Milltek part number: SSXSE256
• Part type: DPF-back exhaust
• Configuration: non-resonated (no intermediate muffler), with valves
• Details: No intermediate muffler, quad Jet-100 carbon tips
• Tube diameter: 76.2 mm (3 inches)
• Outlets: 4 Jet tips, 102 mm
• Tip finish: carbon
• Fitting information: with valves
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Cupra Formentor 2.0TFSI 310 hp (4Drive, 2021-2025)

Not sure whether it fits your vehicle? Contact us with your VIN before ordering.

Most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no intermediate muffler): it is the most expressive, with more crackle on lift-off. On the downside, a slight drone can appear at certain engine speeds on long trips. If you do a lot of highway driving, compare it with the resonated version.
• And the neighbors in the morning? The valves are controlled as on the original: line closed and discreet on startup or in comfort mode, fully open in sport mode.
• Fitting: the line uses the original mounting points. A repair shop with the right equipment usually fits it in one to two hours.

Why choose Milltek Sport?

Milltek Sport designs and manufactures its exhausts in England, with mandrel-bent tubing to preserve the inner diameter and a fit developed on the vehicle. The result: a clean installation with no modification needed, and a sound tuned to stay pleasant for everyday driving.

Further reading

• Resonated or non-resonated cat-back: which one for your car?
• Valved exhaust: how it works and should you keep the valves?