FAP Back Milltek Cupra Ateca 2.0 TSI 300hp 2019-2025 with DPF - non-resonated - Quad Jet-100 Carbon Tips

Milltek Sport FAP-back exhaust for Cupra Ateca

Replacing the original exhaust with a Milltek Sport FAP-back system brings back the character that the Cupra Ateca's engine holds back from the factory: a rounder tone at idle that opens up cleanly through the rev range, without gimmicks.

Technical specifications

• Milltek reference: SSXSE222
• Product type: FAP-back exhaust
• Configuration: non-resonated (without resonator), with valves
• Details: Without resonator - quad Jet-100 carbon tips
• Pipe diameter: 76.2 mm (3 inch)
• Tips: 4 Jet tips, 102 mm
• Tip finish: carbon
• Fitting information: With valves
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Cupra Ateca 2.0TSi 300 hp (4Drive, 2019-2025, with DPF)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Our most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (without resonator): it is the most expressive, with more crackle on lift-off. The trade-off is that a slight drone can appear at certain engine speeds on long trips. If you do a lot of highway driving, compare it with the resonated version.
• And the neighbors in the morning? The valves are controlled as on the original: closed and discreet on startup or in comfort mode, fully open in sport mode.
• Fitting: the system uses the original mounting points. A workshop typically fits it in one to two hours.

Why choose Milltek Sport?

Milltek Sport designs and manufactures its exhausts in England, with mandrel-bent tubes to preserve the internal diameter and a fit developed on the vehicle. The result: a clean installation, no modification needed, and a tone tuned to stay pleasant for everyday use.

For further reading

• Resonated or non-resonated cat-back exhaust: which to choose for your car?
• Valved exhaust: how it works and should you keep them?