DPF Back Milltek Seat Leon 5F Cupra ST 2.0 TSI 2019-2020 with DPF - non-resonated with rear muffler - Quad GT80 Polished Tips

DPF-back Milltek Sport Exhaust System for Seat Leon 5F Cupra ST

On the Seat Leon 5F Cupra ST, the factory exhaust is designed for quiet operation and regulatory compliance. This DPF-back Milltek Sport stainless steel exhaust system gives the engine its voice back, with a refined, full, deep tone that has built the reputation of this British brand.

Technical Specifications

• Milltek part number: SSXSE239
• Part type: DPF-back exhaust system
• Configuration: non-resonated (no resonator)
• Details: No resonator, with rear muffler: quad GT80 polished stainless steel tips
• Tube diameter: 76.2 mm (3 inch)
• Outlets: 4 GT80 outlets, 80 mm
• Tip finish: polished stainless steel
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible Vehicles

• Seat Leon 5F Cupra ST 2.0 TSI 300 hp (4drive, Wagon, 2019-2020, with DPF)

Not sure it fits your vehicle? Contact us with your chassis number (VIN) before ordering.

Most Frequently Asked Questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. On the downside, a slight drone may occur at certain engine speeds on long trips. If you do a lot of highway driving, compare it with the resonated version.
• Installation: the system uses the original mounting points. A shop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

A benchmark among European tuners, Milltek Sport develops each of its systems directly on the vehicle. Mandrel bending, clean welds and aerospace-grade stainless steel ensure a system that lasts and sounds right.

Further Reading

• Cat-back exhaust, resonated or non-resonated: which one should you choose for your car?