STXTA Coilovers ST Suspensions BMW 3 Series

STXTA ST Suspensions coilovers for BMW 3 Series (E36), (3B, 3/B,3C, 3/C, 3/CG) Sedan, Wagon, Coupe, Convertible

Years: 09/90-05/92

Maximum permitted front axle weight (in Kg): -900

Maximum permitted rear axle weight (in Kg): -1150

Front lowering in mm: 40-80

Rear lowering in mm: 30-60

Derived from motorsport, the STX-TA range offers ultra-precise ride height adjustment along with damping adjustment. Ride height is adjusted at the front and rear (where applicable) by a dial located on the threaded body of the shock absorber. They come with adjustable aluminum strut mounts for precise camber adjustment to suit your needs. Galvanized finish plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if your vehicle only has springs at the rear as original equipment, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

Fitting may require wheel spacers.

For models built before 6/92, the following parts must be replaced: Bearing: REF. BMW 31 331 092 885 + strut mount: REF. BMW 31 331 116 983 + dust boot: REF. BMW 31 331 110 196.