STXTA Coilovers ST Suspensions AUDI S3

STXTA ST Suspensions coilover kit for AUDI S3 (8V) without adaptive suspension, Sedan and Sportback body styles, from 05/13. Part number 1821080M#2.

• Front lowering: 0 to 30 mm
• Rear lowering: 5 to 30 mm
• Maximum permitted front axle load: up to 1100 kg
• Maximum permitted rear axle load: up to 1040 kg
• Precise height adjustment and damping adjustment, derived from motorsport (STX-TA range)
• Front and rear height adjustment via a disc on the threaded body of the shock absorber
• Adjustable aluminum strut mounts included, for precise camber adjustment
• Galvanizing and anti-corrosion coating; galvanized steel strut tubes

Fitting and contents

The coilovers are supplied in quantities sufficient to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has rear springs as original equipment, the same applies to this kit. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts. ST Suspensions is a KW brand, and its products are manufactured by KW.

To check before ordering

• On M-Tech equipped models, only use lowering spring kits: the lowering will be 20 mm less than indicated.
• Kit intended for models with a 55 mm diameter strut on the front axle.
• For vehicles with adaptive suspension, the disconnect box is required (part number 68510370).