STXA threaded coilovers ST Suspensions SKODA Octavia III

Years: 02/13-

Maximum permitted front axle load (in Kg): -925

Maximum permitted rear axle load (in Kg): -1050

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range allows adjustment of BOTH ride height AND damping. Height adjustment on the front and rear (where the vehicle allows it) via a collar located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For all those who need to fine-tune their setup to get a personalized "setup." Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has rear springs as original equipment, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspension kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential to lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please contact us using the contact form.

Technical note to consider before ordering:

ON models equipped with M-Tech, use only the lowering springs. The lowering will be 20mm less than indicated

FOR models with 55mm diameter strut on the front axle.