STXA threaded coilovers ST Suspensions SEAT Leon III

The ST Suspensions STXA coilovers (ref. 1828000N#2) fit the SEAT Leon III (5F), including Cupra 265 and Cupra 280, from 03/14. Derived from motorsport, the STXA range allows height and damping adjustment.

Key features

• Front lowering: 15-45 mm
• Rear lowering: 10-35 mm
• Maximum permitted weight on front axle (kg): -1080
• Maximum permitted weight on rear axle (kg): -980
• Front and rear height adjustment (on vehicles that allow it) via a ring on the threaded body of the shock absorber
• Progressive damping adjustment via a knob on the top of the shock absorber shaft, for a personalized setup
• Galvanized finish and anti-corrosion coating; strut assemblies in galvanized steel
• ST Suspensions brand products, manufactured by KW

Fitting and contents

The kit is supplied in sufficient quantity to equip the vehicle and replaces the original suspension without modification. If your vehicle only has springs at the rear as standard, the kit will also have springs at the rear.

Only STXTA models are sold with strut mounts: for other models, use original strut mounts for installation. Kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required.

Technical notes:

• For models with 55 mm strut diameter on the front axle.
• The original electronic suspension control system must be deactivated. The deactivation kit is available under reference KW 68510342.