STXA threaded coilovers ST Suspensions SEAT Leon III

The STXA coilovers from ST Suspensions (part number 1828000U#3) fit the SEAT Leon III: Leon ST (5F) 2WD, Cupra 265, Cupra 280. Derived from motorsport, the STXA range allows ride height and damping adjustment.

• Years: 03/15 onwards
• Maximum permitted weight on front axle: -1090 kg
• Maximum permitted weight on rear axle: -1050 kg
• Front lowering: 15-45 mm
• Rear lowering: 10-35 mm
• Galvanized steel struts with anti-corrosion coating

Adjustments

Ride height is adjusted at the front and rear (on vehicles that allow it) using a disc located on the threaded body of the shock absorber. Damping is adjusted very precisely using a progressive knob on top of the shock absorber rod, for a personalized setting.

Fitting and shipping

The coilovers are supplied in the quantity needed to equip the vehicle and replace the original suspension without modification. If your vehicle only has springs at the rear from the factory, this kit will be the same. Only STXTA models are sold with strut mounts: for other models, original strut mounts are required. The kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required.

ST Suspensions is a brand of KW, and its products are manufactured by KW.

Technical note before ordering

• For models with a 55mm strut diameter on the front axle.
• The factory electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.

For any other information, please use the contact form.