STXA ST Suspensions Coilovers SEAT Leon II

ST Suspensions STXA coilovers (ref. 18281022) for Seat Leon II (1P), Ø 50mm struts, model years 09/05 onward. Motorsport-derived, the STXA range allows height and damping adjustment.

Specifications

• Maximum permitted front axle load (kg): 1106-1170
• Maximum permitted rear axle load (kg): -1000
• Front lowering: 30 to 60 mm
• Rear lowering: 35 to 65 mm
• Front and rear height adjustment (on vehicles that allow it) via a disc located on the threaded body of the shock absorber
• Precise damping adjustment via a progressive dial at the top of the shock absorber shaft, for fine-tuning a personalized setup
• Galvanized and anti-corrosion coated
• Galvanized steel struts

Fitting and contents

Coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If your vehicle only has springs at the rear as standard, the same will apply to this kit.

Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for any other model, original strut mounts must be used for fitting.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Technical note before ordering: except 4WD. For models with 50mm strut diameter on the front axle.