STXA ST Suspensions Coilovers SEAT Leon II

STXA ST Suspensions coilovers for SEAT Leon II (1P), Ø 50 mm struts. Derived from motorsport, the STXA range allows height and damping adjustment to fine-tune a custom setup.

Specifications

• Part number: 18281021
• Years: 09/05-
• Maximum permitted front axle weight: 1036-1105 kg
• Maximum permitted rear axle weight: -1000 kg
• Front lowering: 30-60 mm
• Rear lowering: 35-65 mm
• Height adjustment at the front and rear (on vehicles that allow it) via a disc on the threaded body of the shock absorber
• Very precise damping adjustment via a progressive knob on the top of the shock absorber shaft
• Galvanized and anti-corrosion coating for extended service life
• Struts made of galvanized steel

Installation & delivery

Coilovers are supplied in sufficient quantity to equip the vehicle and replace the original suspension without modification. If the vehicle only has springs at the rear as standard, the same will apply to these kits.

Only STXTA models are sold with strut mounts: for all other models, original strut mounts are required for installation. Kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Technical note before ordering

Except 4WD. For models with 50 mm strut diameter on the front axle.