STXA ST Suspensions Coilovers BMW 4 Series

STXA ST Suspensions coilovers for BMW 4 Series (F32, F33, F36), (3C) Coupe, 2WD without electronically controlled suspension. Developed from motorsport, the STXA range allows height and damping adjustment.

Specifications

• Part number: 1822000F#6
• Years: from 10/13
• Maximum permitted front axle weight: 951 to 1090 kg
• Maximum permitted rear axle weight: up to 1230 kg
• Front lowering: 40 to 65 mm
• Rear lowering: 30 to 60 mm
• Front and rear height adjustment (on vehicles that allow it) via a disc located on the threaded body of the shock absorber
• Progressive damping adjustment via a knob on the top of the shock absorber rod, to fine-tune a custom setup
• Galvanizing and anti-corrosion coating
• Strut legs in galvanized steel

Installation and delivery

Coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has springs at the rear from factory, the kit will be the same.

Only STXTA coilovers are sold with strut mounts. For any other model, original strut mounts are required for installation. Kits ship bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Technical note before ordering

On models equipped with M-Tech, only use the lowering spring kits. The lowering will then be 20 mm less than indicated.