STXA ST Suspensions Coilovers BMW 4 Series

STXA coilovers from ST Suspensions for BMW 4 Series (F32, F33, F36), (3C) Gran Coupe, 2WD without adaptive dampers. Motorsport-derived, the STXA range allows height and damping adjustment.

Specifications

• Part number: 1822000H#3
• Years: from 03/14
• Maximum permitted front axle load: up to 950 kg
• Maximum permitted rear axle load: up to 1265 kg
• Front lowering: 40 to 65 mm
• Rear lowering: 40 to 65 mm
• Front and rear height adjustment (where the vehicle allows it) via a disc located on the threaded body of the shock absorber
• Progressive damping adjustment via a dial on the top of the shock absorber rod, to fine-tune a custom setup
• Galvanization and anti-corrosion coating
• Galvanized steel struts

Installation and shipping

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has springs at the rear as original equipment, the kit will be the same.

Only STXTA coilovers are sold with strut mounts. For any other model, original strut mounts are required for fitting. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential to lowering is required.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Technical note before ordering

On M-Tech equipped models, use only lowering springs. Lowering will then be 20 mm less than indicated.