STXA ST Suspensions coilovers BMW 3 Series

STXA coilover kit by ST Suspensions for BMW 3 Series (F30, F31), (3L, 3K) Touring, 2WD without electronically controlled suspension. Motorsport-derived, the STXA range offers adjustable ride height and damping.

Specifications

• Part number: 1822000J
• Years: from 08/12
• Maximum permitted front axle load: 914 to 1020 kg
• Maximum permitted rear axle load: 1265 kg maximum
• Front lowering: 40 to 65 mm
• Rear lowering: 30 to 55 mm
• Front and rear ride height adjustment (where the vehicle allows) via a dial located on the threaded body of the shock absorber
• Precise damping adjustment via a progressive knob on top of the shock absorber rod, to fine-tune your "setup"
• Galvanized treatment and anti-corrosion coating; galvanized steel strut bodies

Installation and delivery

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle is only fitted with rear springs as original equipment, the same applies to this kit.

Only STXTA models are sold with strut mounts: for this kit, use original strut mounts for installation. The kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. ST Suspensions is a KW brand, and its products are manufactured by KW.

Technical note before ordering

On models fitted with M-Tech, only use lowering springs. The lowering will be 20 mm less than the figure indicated.