STXA ST Suspensions Coilovers BMW 2 Series

The STXA ST Suspensions coilovers ref. 1822000F#3 fit the BMW 2 Series (F22, F23), (1C) Coupe, 2WD, without adaptive suspension, from 02/14. Derived from motorsport, the STXA range allows adjustment of both ride height and damping firmness.

• Lowering: 25 to 50 mm front, 25 to 50 mm rear
• Maximum permitted front axle load: 921 to 1090 kg
• Maximum permitted rear axle load: up to 1230 kg
• Ride height: front and rear adjustment (on vehicles that allow it) via a disc placed on the threaded body of the shock absorber
• Damping firmness: precise adjustment via a progressive knob on the top of the shock shaft
• Protection: galvanization and anti-corrosion coating, galvanized steel strut assemblies

Fitting and shipping

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If your vehicle only has springs at the rear as standard, this kit will be the same. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA coilovers are sold with strut mounts: for other models, provide original strut mounts for fitting.

ST Suspensions is a KW brand, and its products are manufactured by KW.

To check before ordering: on models equipped with M-Tech, use only lowering springs. The lowering will then be 20 mm less than indicated.