STXA Coilovers ST Suspensions VOLKSWAGEN Vento

The STXA ST Suspensions 18280004#3 coilovers fit the Volkswagen Vento (11/1991 - 12/1997) and Golf III (1HX0,1H,1EX0,1E), 2WD, sedan and convertible. The STXA range, derived from motorsport, allows adjustment of both height and damping.

• Reference: 18280004#3
• Years: 09/91 -
• Maximum permitted weight on front axle: 891 to 980 kg
• Maximum permitted weight on rear axle: up to 880 kg
• Front lowering: 45 to 80 mm
• Rear lowering: 45 to 80 mm
• Struts: galvanized steel, with anti-corrosion coating

Adjustment

Ride height is adjusted at the front and rear (on vehicles that allow it) using a disc on the threaded body of the shock. Damping is adjusted very precisely with a progressive knob on the top of the shock shaft, for a custom setup.

Fitting and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If your vehicle only has rear springs as standard, this kit will be the same.

The kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA coilovers are sold with strut mounts: for other models, use original strut mounts. ST Suspensions is a brand of KW and its products are manufactured by KW.

Technical note before ordering

Not suitable for 4WD versions. Fitting may require wheel spacers.