STXA coilovers ST Suspensions SEAT Toledo II

The STXA coilovers from ST Suspensions for SEAT Toledo II (1M), ref. 18282002, are derived from motorsport. They allow height and damping adjustment.

Specifications

• Years: 04/99- (period indicated: 10/1998-07/2004)
• Maximum permitted front axle load: -1020 kg
• Maximum permitted rear axle load: -1020 kg
• Front lowering: 35-65 mm
• Rear lowering: 35-65 mm
• Height adjustment at front and rear (where the vehicle allows) via a disc located on the threaded body of the shock absorber
• Precise damping adjustment via a progressive knob at the top of the shock absorber shaft, to fine-tune a custom setup
• Galvanizing and anti-corrosion coating for extended service life
• Struts in galvanized steel

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has springs at the rear as standard, this kit will be the same.

Only STXTA coilovers are sold with strut mounts. For all other models, original strut mounts are required for installation. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required.

Technical note before ordering

• Installation may require track width spacers.
• For 50 mm diameter models, it is strongly recommended to replace the original anti-roll bar to avoid contact with the right-hand axle shaft: use anti-roll bar 66550008 (ordered separately). (91)
• For extreme lowering, it is strongly recommended to replace the anti-roll bar to avoid contact with the right-hand axle shaft: non-xenon headlight version, anti-roll bar REF. 685 50 000; xenon headlight version, anti-roll bar REF. 685 50 005.

ST Suspensions is a KW brand, and its products are manufactured by KW.