STXA Coilovers ST Suspensions AUDI A3

STXA coilovers from ST Suspensions for Audi A3 (8L) 2WD are derived from motorsport. They offer height and damping adjustment.

• Years: 09/96-
• Maximum permitted front axle weight (in kg): -1020
• Maximum permitted rear axle weight (in kg): -1025
• Front lowering: 30-70 mm
• Rear lowering: 30-70 mm
• Front and rear height adjustment (on vehicles that allow it) via a disc on the threaded body of the shock absorber
• Progressive damping adjustment via a knob on the top of the shock absorber rod, for fine-tuning a custom setup
• Galvanized finish and anti-corrosion coating; galvanized steel strut legs

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and replace the original suspension without modification. If your vehicle only has springs at the rear as standard, the same applies to this kit. Kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The only models sold with strut mounts are the STXTA: for the others, original strut mounts are required for installation. ST Suspensions is a brand of KW, and its products are manufactured by KW.

Technical notes before ordering:

• Installation may require wheel spacers.
• For 50 mm diameter models, it is strongly recommended to replace the original sway bar to avoid contact with the right-hand wheel shaft: use sway bar 66550008 (to be ordered separately). (91)
• For extreme lowering, it is strongly recommended to replace the sway bar to avoid contact with the right-hand wheel shaft: non-Xenon headlight version, sway bar REF. 685 50 000; Xenon headlight version, sway bar REF. 685 50 005.