STXA Coilovers ST Suspensions AUDI A3

The coilovers STXA ST Suspensions (part number 1821000J) are fitted to the Audi A3 (8V) from 05/2012, with independent height and damping adjustment.

Features

• STXA range, derived from motorsport
• Height adjustment at front and rear (where the vehicle allows) via a dial on the threaded body of the shock absorber
• Precise damping adjustment via a progressive dial at the top of the shock absorber shaft
• Front lowering: 30-60 mm
• Rear lowering: 30-55 mm
• Maximum permitted front axle weight: 980 kg
• Maximum permitted rear axle weight: 990 kg
• Galvanizing and anti-corrosion coating
• Galvanized steel struts

Fitment

Audi A3 (8V) without electronically controlled suspension, Sedan and Sportback, 2WD, models with independent rear suspension (IRS) and Ø 50 mm struts.

Installation and shipping

The coilovers are supplied in sufficient quantity to fit the vehicle and fit in place of the original suspension, without modification. If the vehicle only has rear springs as standard, the same applies to this kit. They are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA coilovers are sold with strut mounts: for other models, use original strut mounts. ST Suspensions is a KW brand, and its products are manufactured by KW.

Technical note before ordering

• On M-Tech equipped models, only use lowering spring kits: the lowering will be 20 mm less than indicated.
• Kit intended for models with Ø 50 mm front struts.
• For vehicles fitted with electronically controlled suspension, the disconnect box is required, part number 68510370.