STXA Coilovers ST Suspensions AUDI A3

The STXA coilovers from ST Suspensions (ref. 18210070) fit the Audi A3 8P, including Sportback, with Ø 50 mm strut legs. Derived from motorsport, the STXA range allows both ride height and damping to be adjusted.

Features

• Front and rear height adjustment (on vehicles that allow it) via a disc on the threaded body of the shock absorber
• Damping adjustment via a progressive knob at the top of the shock absorber rod
• Galvanization and anti-corrosion coating
• Galvanized steel strut legs
• Front lowering: 35 to 65 mm
• Rear lowering: 35 to 65 mm
• Maximum permitted front axle weight: 1106 to 1170 kg
• Maximum permitted rear axle weight: up to 1005 kg
• Years: from 03/03

Fitting and shipping

The coilovers are supplied in sufficient quantity to fit the vehicle and replace the original suspension without modification. If the vehicle only has rear springs as standard, this kit will be the same. Kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. Only the STXTA coilovers are sold with strut mounts: for any other model, original strut mounts are required for fitting.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

To check before ordering

• Excluding four-wheel drive vehicles
• For models with Ø 50 mm strut on the front axle
• On vehicles equipped with Audi Magnetic Ride, make sure it is disconnected. A disconnection kit is available in the KW accessories range under ref. 68510124.