STXA Coilovers ST Suspensions AUDI A3

Coilovers STXA from ST Suspensions (ref. 18210039) fit the Audi A3 8P, including Sportback, with Ø 55 mm struts. Derived from motorsport, the STXA range lets you adjust both ride height and damping.

Features

• Front and rear ride height adjustment (on vehicles that allow it) via a disc located on the threaded body of the shock absorber
• Damping adjustment via a progressive knob on top of the shock absorber shaft
• Galvanization and anti-corrosion coating
• Galvanized steel struts
• Front lowering: 35 to 65 mm
• Rear lowering: 35 to 65 mm
• Maximum permitted front axle weight: 1036 to 1105 kg
• Maximum permitted rear axle weight: up to 1005 kg
• Years: from 03/03

Fitting and shipping

The coilovers are supplied in sufficient quantity to equip the vehicle and replace the original suspension without modification. If the vehicle only has rear springs from the factory, the same applies to this kit. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only the STXTA coilovers are sold with strut mounts: for all other models, original strut mounts are required for installation.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

To check before ordering

• Not for 4WD vehicles
• For models with a Ø 55 mm strut on the front axle
• On vehicles equipped with Audi Magnetic Ride, make sure it is disconnected. A disconnect kit is available in the KW accessories range under ref. 68510124.