STX threaded coilovers ST Suspensions SEAT Leon III

STX ST Suspensions coilovers, part number 1328000U#3, for SEAT Leon ST (5F) 2WD, Cupra 265 and Cupra 280. Derived from motorsport, the STX range offers precise height adjustment with a factory-set fixed damping.

• Years: from 03/15
• Maximum permitted front axle load: up to 1090 kg
• Maximum permitted rear axle load: up to 1050 kg
• Front lowering: 15-45 mm
• Rear lowering: 10-35 mm
• Galvanized steel struts with anti-corrosion coating

Fitting and adjustment

Height adjustment is made at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If your vehicle only has springs at the rear as standard, the same applies to these kits.

Only STXTA models come with strut mounts. For other models, original strut mounts are required for installation. The kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. ST Suspensions is a KW brand, and its products are manufactured by KW.

Technical note

This kit applies to models with a 55 mm diameter strut on the front axle. The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.