STX threaded coilovers ST Suspensions SEAT Leon III

The ST Suspensions STX coilovers (part no. 1328000H) are designed for the SEAT Leon (5F), 2WD, with independent rear suspension (IRS) and Ø 50mm struts. Motorsport-derived, the STX range offers precise height adjustment and a fixed, factory-set damping rate.

• Years: 11/12-
• Maximum permitted front axle load: 966-1080 kg
• Maximum permitted rear axle load: -980 kg
• Front lowering: 35-65 mm
• Rear lowering: 35-65 mm
• Height adjustment front and rear (where the vehicle allows it) via a disc on the threaded shock absorber body
• Galvanized steel struts, with galvanizing and anti-corrosion coating

Fitting and contents

The coilovers are supplied in quantities sufficient to equip the vehicle and replace the original suspension without modification. If the vehicle only has springs at the rear as standard, the same applies to this kit. They are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for the others, original strut mounts are required for installation.

ST Suspensions is a brand of KW, and its products are manufactured by KW.

Pre-order technical note

• For models with a 50mm strut diameter on the front axle.
• The factory electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.

For further information, use the contact form.