STX threaded coilovers ST Suspensions SEAT Leon III

The STX coilovers from ST Suspensions 1328000N#2 are designed for the SEAT Leon III (5F) Cupra 265 and Cupra 280. Derived from motorsport, the STX range offers very precise height adjustment.

Specifications

• Years: from 03/14
• 55 mm struts
• Maximum permitted front axle load: up to 1080 kg
• Maximum permitted rear axle load: up to 980 kg
• Front lowering: 15-45 mm
• Rear lowering: 10-35 mm
• Factory-set, non-adjustable damping
• Front and rear height adjustment (on vehicles that allow it) via a dial located on the threaded body of the shock absorber
• Galvanized and anti-corrosion coated, galvanized steel struts

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has rear springs as standard, the kit will likewise use rear springs only.

The kit is supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for other models, use the original strut mounts.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Technical note before ordering: this kit applies to models with a 55 mm strut diameter on the front axle. The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.