STX threaded coilovers ST Suspensions SEAT Leon III

The STX ST Suspensions 1328000U#2 coilovers fit the SEAT Leon III (5F) (09/2012 - Today), in Leon ST (5F) wagon version, 2WD, for models with independent rear suspension (IRS) and Ø 55 mm struts.

• Reference: 1328000U#2
• Years: 11/13 -
• Maximum permitted front axle load: 966 to 1090 kg
• Maximum permitted rear axle load: up to 1050 kg
• Front lowering: 35 to 65 mm
• Rear lowering: 35 to 65 mm
• Struts: galvanized steel, with anti-corrosion coating

Adjustment

Derived from motorsport, the STX range offers precise ride height adjustment, with a fixed damping rate set at the factory. Height is adjusted at the front and rear (on vehicles that allow it) using a disc placed on the threaded body of the shock absorber.

Fitment and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If your vehicle only has original rear springs, the same will apply with this kit.

Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA coilovers are sold with strut mounts: for other models, original strut mounts are required. ST Suspensions is a KW brand and its products are manufactured by KW.

Technical note before ordering

This model applies to vehicles with Ø 55 mm struts on the front axle. The original electronic suspension control system must be deactivated: the deactivation kit is available under reference KW 68510342.