STX Threaded Coilovers ST Suspensions AUDI A3

STX ST Suspensions coilovers fit the AUDI A3 (8V) without adaptive dampers, Sedan and Sportback, 2WD, models with independent rear suspension (IRS) and Ø 55mm struts. Derived from motorsport, the STX range offers very precise height adjustment, with a factory-set fixed damping.

• Years: 05/12-
• Maximum permitted axle load, front (kg): -980
• Maximum permitted axle load, rear (kg): -990
• Front lowering: 30-60 mm
• Rear lowering: 30-55 mm
• Height adjustment at front and rear (where the vehicle allows) via a dial located on the threaded body of the shock absorber
• Galvanized finish and anti-corrosion coating for extended service life
• Galvanized steel struts

Fitting and shipping

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle and replace the original suspension without modification. If the vehicle only has rear springs as standard, this will also be the case with these kits. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for all other models, use original strut mounts. ST Suspensions is a KW brand, and its products are manufactured by KW.

Technical notes before ordering:

• On vehicles fitted with M-Tech, only use lowering springs: the lowering will be 20 mm less than indicated.
• For models with 55 mm diameter strut on the front axle.
• For vehicles fitted with adaptive suspension, the disconnect box is required. Part number 68510370.