STX Threaded Coilovers ST Suspensions AUDI A3

STX coilovers from ST Suspensions (part number 1321000G) fit the Audi A3 (8V) without electronically controlled suspension, sedan and Sportback included, in two-wheel drive. Developed from motorsport, the STX range offers precise height adjustment and a fixed, factory-set damping rate.

Specifications

• Vehicle: Audi A3 (8V) without electronically controlled suspension, Sedan + Sportback, two-wheel drive, models with independent rear suspension (IRS), Ø 50 mm struts
• Years: 05/12-
• Maximum permitted front axle load: 981-1075 kg
• Maximum permitted rear axle load: -990 kg
• Front lowering: 30-60 mm
• Rear lowering: 30-55 mm
• Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber
• Galvanization and anti-corrosion coating for extended service life; struts in galvanized steel

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and install in place of the original suspension, without modification. If your vehicle only has rear springs from the factory, the same applies to this kit. Kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for all other models, original strut mounts are required for installation.

ST Suspensions is a KW brand, and its products are manufactured by KW. For any further information, you can use the contact form.

Technical notes before ordering

• On models with M-Tech, only use lowering springs. Lowering will be 20 mm less than indicated.
• For models with Ø 50 mm struts on the front axle.
• For vehicles with electronically controlled suspension, the disconnect box is required: part number 68510370.