STX ST Suspensions Coilovers SEAT Toledo II

STX coilovers by ST Suspensions for SEAT Toledo II (1M) allow precise ride height adjustment, with a fixed, factory-set damping rate. The STX range is derived from motorsport.

• Part number: 13282002
• Vehicle: SEAT Toledo II (1M), years 04/99 and later
• Lowering: 35 to 65 mm front, 35 to 65 mm rear
• Maximum permitted axle weight: -1020 kg front, -1020 kg rear
• Height adjustment: front and rear (on vehicles that allow it), via a disc on the threaded body of the shock absorber
• Protection: galvanizing and anticorrosion coating; struts in galvanized steel

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If your vehicle only has rear springs as standard, the same applies to this kit. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential to lowering is required. Only STXTA coilovers are sold with strut mounts: for all other models, original strut mounts are required for fitting.

Technical notes before ordering

• Fitting may require wheel spacers.
• For 50 mm diameter models, it is strongly recommended to replace the original sway bar to avoid any contact with the right-hand axle shaft: use bar part no. 66550008 (sold separately).
• In case of extreme lowering, replacing the sway bar is also strongly recommended, for the same reason. Version without xenon headlights: bar part no. 685 50 000. Version with xenon headlights: bar part no. 685 50 005.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.