STX ST Suspensions Coilovers FIAT Barchetta

The STX ST Suspensions coilovers (ref. 13240004) fit the FIAT Barchetta (183) from 05/1995. Derived from motorsport, the STX range offers precise height adjustment with a fixed damping rate set at the factory.

• Height adjustment: via a dial on the threaded body of each shock absorber, front and rear (on vehicles that allow it)
• Front lowering: 30 to 70 mm
• Rear lowering: approx. 40 mm
• Maximum permitted weight: 850 kg on the front axle, 700 kg on the rear axle
• Protection: galvanized finish and anti-corrosion coating, galvanized steel strut tubes

Fitting and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension without modification. If the vehicle only has rear springs from the factory, the kit will be the same. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for other models, use original strut mounts.

Technical note before ordering

Front height adjustable. Rear consists of lowering springs and sport shock absorbers. Some parts must be sourced from the manufacturer (FIAT references: bearing support 777 59 40, seal 779 52 59 and washer 779 52 60).