STX ST Suspensions coilovers AUDI Q5 Quattro

STX ST Suspensions coilovers ref. 13210089 fit the Audi Q5 Quattro (8R, 8R1), in 2WD as well as 4WD. The STX range, derived from motorsport, combines precise height adjustment with fixed factory-set damping.

Specifications

• Years: from 09/08
• Maximum permitted front axle load: up to 1220 kg
• Maximum permitted rear axle load: up to 1360 kg
• Front lowering: 40-80 mm
• Rear lowering: 45-85 mm
• Height adjustment front and rear (where the vehicle allows) via a dial located on the threaded body of the shock absorber
• Galvanized finish and anti-corrosion coating
• Galvanized steel strut legs

Fitting and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and replace the original suspension without modification. If your vehicle only has rear springs as original equipment, the same applies to this kit. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for all other models, use original strut mounts for installation.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Technical note before ordering: for vehicles fitted with electronically controlled suspension, check that it is disconnected. A disconnection kit is listed in the KW accessories range, ref. 68510144.