STX coilovers ST Suspensions VOLKSWAGEN Golf VII 4Motion

STX ST Suspensions coilovers fit the Volkswagen Golf VII (AU) Sedan 4Motion, 4WD models with independent rear suspension (IRS) and Ø 50 mm strut legs. Part number: 1328000G#2.

Specifications

• Years: from 11/2012
• Maximum permitted front axle load: up to 965 kg
• Maximum permitted rear axle load: up to 980 kg
• Front lowering: 35 to 65 mm
• Rear lowering: 40 to 65 mm
• STX range derived from motorsport, with factory-set fixed damping
• Ride height adjustment at front and rear (where the vehicle allows) via a disc located on the threaded body of the shock absorber
• Galvanizing and anti-corrosion coating; galvanized steel strut legs

Fitting and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle originally has springs only at the rear, the same applies to this kit. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for this kit, plan to use original strut mounts for fitting.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Technical notes before ordering

• On M-Tech equipped models, only use the lowering spring kits: the lowering will be 20 mm less than indicated.
• Kit designed for models with Ø 50 mm strut legs on the front axle.
• The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.