STX coilovers ST Suspensions VOLKSWAGEN Golf VII 4Motion

STX coilovers by ST Suspensions fit the Volkswagen Golf VII (AU) Sedan 4Motion, four-wheel drive, models with independent rear suspension (IRS) and Ø 55 mm struts. Part number: 1328000N#4.

Specifications

• Years: from 11/2012
• Maximum permitted front axle load: up to 1080 kg
• Maximum permitted rear axle load: up to 980 kg
• Front lowering: 35 to 65 mm
• Rear lowering: 40 to 65 mm
• STX range derived from motorsport, with factory-set fixed damping
• Front and rear height adjustment (where the vehicle allows it) via a disc located on the threaded body of the shock absorber
• Galvanized finish and anti-corrosion coating; galvanized steel struts

Installation & contents

Coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has springs at the rear from the factory, this kit will also be the case. Kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. Only STXTA models are sold with strut mounts: for this kit, original strut mounts are required for installation.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Technical notes before ordering

• On M-Tech equipped models, use only lowering springs: lowering will be 20 mm less than indicated.
• Kit designed for models with 55 mm diameter struts on the front axle.
• The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.