STX Coilovers ST Suspensions AUDI A6 C7 Avant

STX coilovers from ST Suspensions (ref. 1321000E) fit the Audi A6 C7 Avant (4G, 4G1) wagon, two- or four-wheel drive, from 09/11. Derived from motorsport, the STX range combines precise height adjustment with a fixed, factory-set damping rate.

Features

• Front lowering: 40 to 65 mm
• Rear lowering: 40 to 65 mm
• Maximum permitted front axle load: 1171 to 1320 kg
• Maximum permitted rear axle load: up to 1425 kg
• Height adjustment at front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber
• Strut legs in galvanized steel, with anti-corrosion coating

Fitting and shipping

Coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle originally has springs at the rear only, the same applies to this kit.

Only STXTA coilovers are sold with strut mounts. For all other models, original strut mounts are required for fitting. Kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required.

ST Suspensions is a brand of KW, and its products are manufactured by KW.

Technical notes before ordering:

• On models equipped with M-Tech, use only lowering springs: lowering will be 20 mm less than indicated.
• Not suitable for models equipped with ride height correction, unless ride height correction adjustment is required.