Lowering Springs & Shocks Kit for SEAT Leon I

ST Suspensions kit consisting of lowering springs and shock absorbers for the Seat Leon I (1M) 2WD, with a 40 mm drop at the front and rear.

• Vehicle: Seat Leon (1M) 2WD, 1.8, 1.9 TDi
• Years: 09/99 to 08/05
• Compatible power: 66 to 165 kW
• Maximum front axle weight: from 931 to 980 kg
• Maximum rear axle weight: 985 kg
• Front/rear drop: 40/40 mm
• Part no.: 23281025

Technical note before ordering

For 50 mm diameter models, it is strongly recommended to replace the original sway bar to avoid contact with the right-side axle shaft. Use sway bar 66550008, ordered separately.

Installation and notes

The shock absorbers and springs are supplied in sufficient quantity to equip the vehicle and install in place of the original suspension without modification. If the vehicle only has rear springs from the factory, the same will apply to this kit. Original strut mounts are required for installation.

The kit is supplied bare (shock absorber cartridges and/or springs as applicable), unless an accessory essential to lowering is required. Shock absorber cartridges are sold individually: a minimum of 2 must be ordered to equip an axle.

Compatible power ratings are expressed in kW (1 kW = 1.36 hp).