Lowering springs and shock absorbers kit for SEAT Leon III

Years: 09/13-

Compatible vehicle power (in kW): 110-213

Maximum permitted front axle weight (in kg): -1060

Maximum permitted rear axle weight (in kg): -1010

Possible front/rear lowering (in mm): 30/30

Technical note to consider before ordering:

FOR models with a 50 mm diameter strut on the front axle.

The indicated lowering will be less on models fitted with factory sport suspension.

The indicated lowering will be less on models fitted with factory sport suspension.

FOR vehicles with independent axles (wishbone type)

Please note:

ST Suspensions shock absorbers and springs are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has springs at the rear, the same applies to these ST Suspensions kits. Make sure to use the original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and/or springs as applicable), unless an accessory essential for lowering is required.

However, shock absorber cartridges are sold individually! You will therefore need to order at least 2 to equip an axle.

CAUTION: compatible power ratings are expressed in kW (kilowatts). To find the equivalent in cv, this figure must be converted (1kW = 1.36cv). Online converters are also available.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please use our contact form.