Coilovers STXA ST Suspensions VOLKSWAGEN Passat B6 Berline

The STXA coilovers from ST Suspensions (part number 18280075#3) are designed for the Volkswagen Passat (B6, B7), (3C, 3c) Sedan, in both 2WD and 4WD configurations, facelift included. Derived from motorsport, the STXA range allows height and damping adjustment.

• Years: 03/05 to 10/14
• Height adjustment: at the front and rear (on vehicles that allow it), via a disc on the threaded shock absorber body
• Damping adjustment: via a progressive knob at the top of the shock absorber rod, to fine-tune your setup
• Front and rear lowering: 35 to 65 mm
• Maximum permitted front axle load: up to 1105 kg
• Maximum permitted rear axle load: up to 1150 kg
• Protection: galvanizing and anti-corrosion coating, galvanized steel struts

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has springs at the rear as standard, the same will apply with these kits.

Only STXTA models are sold with strut mounts. For any other model, plan to use original strut mounts for installation. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required.

Technical notes before ordering:

• This kit is designed for models with a 55 mm strut diameter on the front axle.
• Vehicles fitted with DDC electronically controlled suspension must have it disconnected. A disconnection kit is available in the KW accessories range, part number 68510141.

ST Suspensions is a KW brand, and its products are manufactured by KW. For any further information, please use the contact form.