Coilovers STXA ST Suspensions VOLKSWAGEN Golf VII 4Motion

STXA coilovers from ST Suspensions, derived from motorsport, fit the VOLKSWAGEN Golf VII 4Motion (AU) sedan. They allow adjustment of both ride height and damping stiffness.

• Make: ST Suspensions
• Part number: 1828000G#3
• Vehicle: VOLKSWAGEN Golf VII, (AU) sedan, four-wheel drive, models with independent rear suspension (IRS), 50mm diameter struts, model years 11/12-
• Maximum permissible front axle load (kg): -965
• Maximum permissible rear axle load (kg): -980
• Front lowering (mm): 35-65
• Rear lowering (mm): 40-65
• Front and rear ride height adjustment (on vehicles that allow it) via a disc placed on the threaded body of the shock absorber
• Precise damping adjustment via a progressive dial at the top of the shock absorber shaft
• Galvanized and anti-corrosion coated

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and install in place of the original suspension, without modification. If the vehicle only has springs at the rear as standard, the same applies to these kits. The struts are made of galvanized steel.

Only the STXTA coilovers are sold with strut mounts. For any other model, plan to use original strut mounts for installation. ST Suspensions kits are shipped bare (shock absorber cartridges and springs where applicable), unless an accessory essential to lowering is required.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Technical note to consider before ordering

• On M-Tech equipped models, use only lowering spring kits: the lowering will be 20mm less than indicated.
• Kit designed for models with a 50mm diameter strut on the front axle.
• The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.