Coilovers STXA ST Suspensions VOLKSWAGEN Golf VII 4Motion

The STXA threaded coilovers from ST Suspensions, derived from motorsport, fit the VOLKSWAGEN Golf VII R (AU) 4Motion Sedan. They allow adjustment of both ride height and damping.

• Make: ST Suspensions
• Part number: 1828000N#6
• Vehicle: VOLKSWAGEN Golf VII R, (AU) Sedan, 4Motion, from 11/13
• Maximum permitted front axle load (kg): -1080
• Maximum permitted rear axle load (kg): -980
• Front lowering (mm): 10-40
• Rear lowering (mm): 20-45
• Front and rear ride height adjustment (on vehicles that allow it) via a disc placed on the threaded body of the shock absorber
• Precise damping adjustment via a progressive dial at the top of the shock absorber shaft
• Galvanizing and anti-corrosion coating

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has springs at the rear as standard, the same applies to these kits. The struts are made of galvanized steel.

Only the STXTA threaded coilovers are sold with strut mounts. For any other model, plan to use original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Technical note to consider before ordering

• On M-Tech equipped models, use only the lowering spring kits: the lowering will be 20mm less than indicated.
• Kit intended for models with 55mm diameter struts on the front axle.
• The original electronic suspension control system must be deactivated. The deactivation kit is available under KW reference 68510342.