Coilovers STXA ST Suspensions VOLKSWAGEN Golf VII

Years: 05/13-

Maximum permitted front axle weight (in kg): -1080

Maximum permitted rear axle weight (in kg): -980

Front lowering in mm: 25-55

Rear lowering in mm: 20-45

Derived from motorsport, the STXA range allows adjustment of BOTH ride height AND damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock. Very precise damping adjustment via a progressive knob at the top of the shock shaft. For anyone who needs to fine-tune their setup to achieve a personalized setup. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have original rear springs, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspension kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Please use our contact form for any other information.

Technical note to consider before ordering:

ON M-Tech models, use only lowering spring kits. The lowering will be 20mm less than indicated

FOR models with 55mm diameter struts on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under reference KW 68510342.