Coilovers STXA ST Suspensions SEAT Toledo III

The STXA coilovers from ST Suspensions for SEAT Toledo III (5P), ref. 18280070#4, are designed for models with Ø 55mm struts. Derived from motorsport, they allow height and damping adjustment.

Specifications

• Years: 10/04- (period indicated: 09/2004-05/2009)
• Maximum permitted front axle load: 1101-1170 kg
• Maximum permitted rear axle load: -1150 kg
• Front lowering: 25-55 mm
• Rear lowering: 30-60 mm
• Height adjustment at front and rear (where the vehicle allows) via a disc located on the threaded body of the shock absorber
• Precise damping adjustment via a progressive knob at the top of the shock absorber shaft, to fine-tune a custom setup
• Galvanizing and anti-corrosion coating for extended service life
• Struts in galvanized steel

Installation and contents

The coilovers are supplied in sufficient quantity to equip the vehicle and fit in place of the original suspension, without modification. If the vehicle only has springs at the rear as standard, this kit will be the same.

Only STXTA coilovers are sold with strut mounts. For all other models, original strut mounts are required for installation. Kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required.

Technical note before ordering

This kit is intended for models with a 55mm diameter strut on the front axle.

ST Suspensions is a KW brand, and its products are manufactured by KW.