Milltek DPF-Back Exhaust Audi RS3 8Y 2.5 TFSI 400 hp 2021-2024 with DPF - 80 mm Version - Non-Resonated - OEM Outlets

Milltek Sport DPF-back exhaust system for Audi RS3 8Y

Replacing the original exhaust with a Milltek Sport DPF-back system brings back the character that the stock engine of your Audi RS3 8Y holds back: a rounder tone at idle, opening up cleanly through the rev range, without gimmicks.

Technical specifications

• Milltek part number: SSXAU967
• Part type: DPF-back exhaust system
• Configuration: non-resonated (no resonator), with valves
• Detail: 80 mm version, no resonator, OEM exhaust tips
• Pipe diameter: 80 mm
• Outlets: original exhaust tips retained
• Tip finish: original style
• Fitting information: With valves, 80 mm pipe diameter
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Audi RS3 8Y 2.5 TFSI 400hp (Quattro, Sedan, 2021-2024, with DPF)

Not sure it fits your vehicle? Contact us with your VIN before ordering.

Most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. On the downside, a slight drone can appear at certain engine speeds on long trips. If you do a lot of motorway driving, compare it with the resonated version.
• What about the neighbors in the morning? The valves are controlled as on the original: closed and discreet at start-up or in comfort mode, fully open in sport mode.
• Fitting: the system uses the original mounting points. A repair shop with the right equipment usually fits it in one to two hours.

Why choose Milltek Sport?

Milltek Sport designs and manufactures its exhausts in England, using mandrel-bent tubing to preserve the internal diameter and a fit developed on the vehicle. The result: a clean installation with no modification needed, and a tone tuned to remain pleasant for everyday use.

Go further

• Resonated or non-resonated cat-back: which one for your car?
• Valved exhaust: how does it work and should you keep the valves?