Milltek Cat-Back Volkswagen Jetta Mk7 - With Primary Muffler - Non-Resonated and Rear Muffler - Dual GT100 Titanium Tips

Milltek Sport Exhaust System for Volkswagen Jetta Mk7 GLI

Replacing the factory exhaust with a Milltek Sport system brings back the character that the engine of your Volkswagen Jetta Mk7 GLI is held back by from the factory: a rounder tone at idle that opens up cleanly at higher RPM, without gimmicks.

Technical Specifications

• Milltek Part Number: SSXVW610
• Part Type: Exhaust system
• Configuration: non-resonated (no center muffler)
• Details: With primary muffler, no center muffler, and rear muffler with GT100 dual titanium tips
• Tube Diameter: 76.2 mm (3 inch)
• Outlets: 2 x 100 mm GT100 tips
• Tip Finish: titanium finish
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible Vehicles

• Volkswagen Jetta Mk7 GLI 2.0T FSI (2019-2024)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Frequently Asked Questions

• Resonated or non-resonated? This version is non-resonated (no center muffler): it is the most expressive, with more crackle on throttle lift-off. In return, a slight drone may be noticeable at certain engine speeds on long highway trips. If you drive a lot on the highway, compare with the resonated version.
• Installation: the system uses the original mounting points. A workshop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

Milltek Sport designs and manufactures its exhausts in England, using mandrel-bent tubing to preserve the internal diameter and a fit developed specifically for each vehicle. The result: a clean installation without modification, and a sound tuned to remain pleasant for everyday driving.

Go Further

• Resonated or non-resonated cat-back: which one to choose for your car?