Milltek Cat-Back Exhaust Audi RS3 8V 2.5 TFSI 400 hp 2017-2020 - 80 mm Version - Non-Resonated - Blued Titanium Oval Tips

Milltek Sport Exhaust System for Audi RS3 8V

Is the factory sound of your Audi RS3 8V leaving you wanting more? This stainless steel Milltek Sport exhaust system is the upgrade owners request most: more presence, a distinctive sound, and build quality that lasts.

Technical specifications

• Milltek part number: SSXAU896
• Part type: Exhaust system
• Configuration: non-resonated (no resonator), with valves
• Details: 80 mm version - No resonator - Blued titanium oval tips
• Pipe diameter: 80 mm
• Outlets: 170 x 107 mm oval outlet
• Tip finish: blued titanium (heat-effect)
• Fitting information: With valves - 80 mm pipe diameter
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Audi RS3 8V 2.5 TFSI 400 hp (Quattro, Sedan, 2017-2018, without DPF)
• Audi RS3 8V 2.5 TFSI 400 hp (Quattro, Sedan, 2019-2020, with DPF)

Not sure about fitment for your vehicle? Contact us with your VIN before ordering.

Most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. The trade-off is a slight drone that can appear at certain engine speeds on long trips. If you do a lot of highway driving, compare it with the resonated version.
• What about the neighbors in the morning? The valves are controlled as on the original: closed and quiet at startup or in comfort mode, fully open in sport mode.
• Installation: the system uses the original mounting points. A shop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

What owners mention most often: fit quality and a deep tone that is present but never harsh. That is the Milltek Sport signature, from a UK manufacturer specializing in stainless steel exhausts.

Going further

• Resonated or non-resonated cat-back exhaust: which one for your car?
• Valved exhaust: how does it work and should you keep the valves?