Milltek Cat-Back Exhaust Audi A3 8P 1.8 TFSI 160hp 2008-2012 - Non-Resonated - Jet-80 Black Cerakote Exhaust Tips

Milltek Sport Exhaust System for Audi A3 8P

On the Audi A3 8P, the factory exhaust is designed for quiet operation and regulatory compliance. This Milltek Sport stainless steel exhaust system gives the engine its voice back with a refined, full, deep tone, the sound that built the reputation of the British brand.

Technical specifications

• Milltek part number: SSXVW149
• Part type: Exhaust system
• Configuration: non-resonated (no resonator)
• Detail: No resonator - Jet-80 black Cerakote exhaust tips
• Tube diameter: 69.85 mm (2.75 inches)
• Exhaust tips: 2 Jet exhaust tips, 80 mm
• Tip finish: black Cerakote (high-temperature ceramic)
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible vehicles

• Audi A3 8P 1.8 TFSi 160 hp (2WD, 3 Doors, 2008-2012)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on throttle lift-off. On the downside, a slight drone may occur at certain engine speeds on long trips. If you do a lot of highway driving, compare it with the resonated version.
• Installation: the system uses the factory mounting points. A repair shop with the right equipment usually fits it in one to two hours.

Why choose Milltek Sport?

Milltek Sport designs and manufactures its exhausts in England, using mandrel-bent tubes to preserve the inner diameter and a fit developed specifically for each vehicle. The result: a clean installation with no modification needed, and a sound tuned to remain pleasant for everyday driving.

Further reading

• Resonated or non-resonated cat-back exhaust: which one should you choose for your car?