Milltek Cat-Back Exhaust Audi A1 8X 1.4 TFSI 122hp 2010-2015 - non-resonated - Twin GT80 Cerakote Black Tips

Milltek Sport exhaust system for Audi A1 8X

Replacing the factory exhaust with a Milltek Sport system brings back the character that the engine of your Audi A1 8X is held back by from the factory: a rounder tone at idle that opens up cleanly through the rev range, without gimmicks.

Technical specifications

• Milltek part number: SSXAU457
• Part type: Exhaust system
• Configuration: non-resonated (no center muffler)
• Details: No center muffler - dual GT80 Cerakote black tips
• Pipe diameter: 63.5 mm
• Outlets: 2 GT80 outlets, 80 mm
• Tip finish: Cerakote black (high-temperature ceramic coating)
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible vehicles

• Audi A1 8X 1.4 TFSi 122 hp (S-Line only, 2WD, 2010-2015)

Unsure about compatibility with your vehicle? Contact us with your VIN before ordering.

Our most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no center muffler): it is the most expressive, with more crackle on lift-off. The trade-off is that a slight drone may appear at certain engine speeds on long trips. If you do a lot of highway driving, compare with the resonated version.
• Installation: the system uses the original mounting points. A equipped shop typically fits it in one to two hours.

Why choose Milltek Sport?

Recognized by European tuners, Milltek Sport develops each of its systems directly on the vehicle. Mandrel bending, careful welds and aerospace-grade stainless steel ensure a system that lasts and sounds right.

Go further

• Resonated or non-resonated half system: which one should you choose for your car?