DPF Back Milltek Volkswagen Transporter T6 - Road resonated and no rear muffler - Twin Oval Black tips - Short Wheelbase (SWB)

DPF-back exhaust for Milltek Sport Volkswagen Transporter T6

Replacing the stock exhaust with a Milltek Sport DPF-back exhaust brings back the character that the engine of your Volkswagen Transporter T6 is held back by from the factory: a rounder sound at idle that opens up freely through the revs, without artifice.

Technical specifications

• Milltek part number: SSXVW472
• Part type: DPF-back exhaust
• Configuration: resonated (with resonator)
• Detail: With Road resonator and no rear muffler - twin oval black tips
• Pipe diameter: 69.85 mm (2.75 inches)
• Outlets: 2 special oval 100 x 80mm outlets
• Tip finish: black Cerakote (high-temperature ceramic)
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible vehicles

• Volkswagen Transporter T6 2.0 TSI 150-204 hp (2WD, Short Wheelbase (SWB), 2017-2019)

Not sure it fits your vehicle? Contact us with your VIN (chassis number) before ordering.

Most frequently asked questions

• Motorway drone? It is the number one concern on forums. This version keeps a resonator (resonated): the sound stays full under acceleration, while the exhaust stays calm at steady speed, ideal for everyday driving.
• Fitting: the line uses the original mounting points. A workshop equipped for the job typically fits it in one to two hours.

Why choose Milltek Sport?

A reference among European tuners, Milltek Sport develops each of its lines directly on the vehicle. Mandrel bends, careful welds and aerospace-grade stainless steel ensure a line that lasts and sounds right.

Going further

• Resonated or non-resonated cat-back exhaust: which one should you choose for your car?