DPF Back Milltek Seat Leon 1P FR 2.0 TDI 170hp 2005-2013 - non-resonated - Twin Oval Polished tips - Special Oval outlets

Milltek Sport DPF-back exhaust for Seat Leon 1P FR

On the Seat Leon 1P FR, the original exhaust is designed for quietness and regulations. This Milltek Sport stainless steel DPF-back system brings back the engine's voice with a refined, full and deep sound, the one that built the reputation of this British brand.

Technical specifications

• Milltek part number: SSXSE129
• Product type: DPF-back exhaust
• Configuration: non-resonated (no resonator)
• Details: No resonator - twin polished stainless Oval tips
• Pipe diameter: 69.85 mm (2.75 inches)
• Outlets: special oval outlet
• Tip finish: polished stainless steel
• Fitting information: Cupra look (Oval outlet)
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible vehicles

• Seat Leon 1P FR 2.0 TDI 170 hp (2WD, 2005-2013)

Not sure about compatibility with your vehicle? Contact us with your chassis number (VIN) before ordering.

Frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. On the other hand, a slight drone may appear at certain engine speeds on long trips. If you do a lot of motorway driving, compare it with the resonated version.
• Fitting: the system uses the original mounting points. A workshop equipped for the job typically fits it in one to two hours.

Why choose Milltek Sport?

A benchmark among European tuners, Milltek Sport tunes each of its systems directly on the vehicle. Mandrel bending, careful welds and aerospace-grade stainless steel make for a system that lasts and sounds right.

Going further

• Resonated or non-resonated cat-back: which one to choose for your car?