DPF Back Milltek Cupra Leon KL Sportstourer 2021-2025 / Seat Leon 5F Cupra ST 2019-2020 - non-resonated - Polished Oval Outlets

Milltek Sport FAP-back exhaust for Cupra Leon KL Sportstourer / Seat Leon 5F Cupra ST

Replacing the factory exhaust with a Milltek Sport FAP-back system brings back the character that the engine of your Cupra Leon KL Sportstourer / Seat Leon 5F Cupra ST muffles from the factory: a rounder tone at idle that opens up clearly through the rev range, without gimmicks.

Technical specifications

• Milltek part number: SSXSE236
• Part type: FAP-back exhaust
• Configuration: non-resonated (no resonator)
• Details: No resonator - Polished stainless steel oval tips
• Tube diameter: 76.2 mm (3 inch)
• Outlets: 152 x 76 mm oval outlet
• Tip finish: polished stainless steel
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible vehicles

• Cupra Leon KL Sportstourer 2.0TSI 310-333 hp (4 Drive, Wagon, 2021-2025, with DPF)
• Seat Leon 5F Cupra ST 2.0 TSI 300 hp (4Drive, Wagon, 2019-2020, with DPF)

Not sure about fitment for your vehicle? Contact us with your VIN before ordering.

Our most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. The trade-off is that a slight drone may be noticeable at certain engine speeds on long trips. If you do a lot of highway driving, compare it with the resonated version.
• Fitting: the system uses the original mounting points. A workshop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

A reference among European tuners, Milltek Sport develops each of its systems directly on the vehicle. Mandrel bends, careful welds and aerospace-grade stainless steel make for a system that lasts and sounds right.

Going further

• Resonated or non-resonated half system: which one to choose for your car?