DPF Back Milltek Audi S3 8V2 2.0 TFSI 2013-2020 - non-resonated - Polished Quad Oval Tips

DPF-Back Milltek Sport Exhaust for Audi S3 8V2

Does the original sound of your Audi S3 8V2 leave you wanting more? This stainless steel DPF-back exhaust from Milltek Sport is the one owners ask for most: more presence, a distinctive sound and build quality that lasts.

Technical specifications

• Milltek part number: SSXAU473
• Part type: DPF-back exhaust
• Configuration: non-resonated (no resonator), with valves
• Details: no resonator, quad oval tips in polished stainless steel
• Tube diameter: 76.2 mm (3 inch)
• Outlets: 4 oval outlets
• Tip finish: polished stainless steel
• Installation information: with valves
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

Audi S3 8V2 2.0 TFSI (Quattro, Sedan, Cabriolet, 2019-2020, with DPF)
Audi S3 8V2 2.0 TFSI (Quattro, Sedan, Cabriolet, 2013-2018, without DPF)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Frequently asked questions
Resonated or non-resonated?
• This version is non-resonated (no resonator): it is the most expressive, with more crackling on lift-off. The trade-off is that a slight drone may appear at certain engine speeds on long trips. If you do a lot of motorway driving, compare it with the resonated version.
What about the neighbors in the morning?
• The valves are controlled as on the original: the line stays closed and quiet at startup or in comfort mode, and fully opens in sport mode.
Fitting:

the line uses the original mounting points. A workshop equipped for the job usually fits it in one to two hours.

Why choose Milltek Sport?

A benchmark among European tuners, Milltek Sport develops each of its lines directly on the vehicle. Mandrel bends, careful welds and aerospace-grade stainless steel ensure a line that lasts and sounds right.

Further reading
Resonated or non-resonated half system: which one should you choose for your car?
Valved exhaust system: how does it work and should you keep the valves?