DPF-back Milltek Audi A5 8T 3.0 TDI 2007-2012 with DPF - non-resonated - Quad GT80 Cerakote Black tips

DPF-back Milltek Sport exhaust for Audi A5 8T

Replacing the original exhaust with a Milltek Sport DPF-back system brings back the character that the factory setup holds back on your Audi A5 8T: a rounder tone at idle that opens up cleanly through the rev range, without gimmicks.

Technical specifications

• Milltek reference: SSXAU663
• Part type: DPF-back exhaust
• Configuration: non-resonated (no mid-muffler)
• Detail: No mid-muffler, quad GT80 tips in black Cerakote
• Pipe diameter: 70 mm (2.75 inches)
• Outlets: 4 GT80 outlets of 80 mm
• Tip finish: black Cerakote (high-temperature ceramic)
• Fitting information: Fits with PC S-Line + lower spoiler / detailing strip S5 (2009-2012 part # 8T0 807 521B 1RR and 8T0 807 791 2ZZ) (2012+ part # 8T8 807 521 01C and 8T0 807 791 B 1RR)
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Audi A5 8T 3.0 Tdi (Quattro, Cabriolet, 2009-2012, with DPF)
• Audi A5 8T 3.0 TDi (Quattro, Coupé, 2007-2012, with DPF)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no mid-muffler): it is the most expressive, with more crackle on lift-off. The trade-off is a slight drone that can appear at certain engine speeds on long trips. If you do a lot of motorway driving, compare it with the resonated version.
• Fitting: the system uses the original mounting points. A workshop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

A reference name among European tuners, Milltek Sport develops each of its systems directly on the vehicle. Mandrel-bent tubing, careful welds and aerospace-grade stainless steel ensure a system that lasts and sounds right.

Going further

• Resonated or non-resonated cat-back exhaust: which one should you choose for your car?