Cat-back Road Milltek BMW 2 Series F22 M235i 2014-2015 - non-resonated, Road rear muffler - Dual GT90 Titanium

Milltek Sport exhaust system for BMW 2 Series F22

Replacing the original exhaust with a Milltek Sport system brings back the character that the factory setup holds back on your BMW 2 Series F22: a rounder tone at idle that opens up cleanly through the rev range, with no gimmicks.

Technical specifications

• Milltek part number: SSXBM1028
• Part type: Exhaust system
• Configuration: non-resonated (no resonator), valveless
• Details: no resonator, Road rear muffler, dual GT90 titanium tips
• Tube diameter: 76.2 mm (3 inches)
• Tips: 2 GT90 tips, 90 mm
• Tip finish: titanium finish
• Fitting information: Road version, valveless
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (United Kingdom)

Compatible vehicles

• BMW 2 Series F22 M235i 3.0 twin-turbo 326 hp (non-xDrive, 2WD, Coupe, 2014-2015)

Not sure it fits your vehicle? Contact us with your VIN before ordering.

Our most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. On the other hand, a slight drone may occur at certain engine speeds on long journeys. If you do a lot of highway driving, compare it with the resonated version.
• Valveless: the system delivers its sound at all times. On a vehicle fitted with original valves, a valve delete kit may be required to avoid a warning light (see fitting information).
• Fitting: the system uses the original mounting points. A repair shop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

A trusted name among European tuners, Milltek Sport develops each of its systems directly on the vehicle. Mandrel bending, careful welds and aerospace-grade stainless steel ensure a system that lasts and sounds right.

Going further

• Resonated or non-resonated cat-back exhaust: which one should you choose for your car?
• Valved exhaust system: how does it work and should you keep the valves?